compression stress

It is important formresidual compression stress in lay hardened of the wheel.

滚压力是保证强化效果的最主要参数.

The sturcture, density, hardness, compression modulus, tensile strength, stress relaxation, permanent deformation properties of foam fabricated by blending silicone rubber and EPDM were studied.

研究了硅橡胶/三元乙丙橡胶（Q/EPDM）配方对泡沫合金的结构、密度、硬度、压缩、拉伸、应力松弛等力学性能的影响规律。

When isocyanate index and density increase, compression stress is strengthened , and the compression set is improved.

增加异氰酸酯指数和密度,微孔弹性体的压缩负荷显著提高, 压缩变定性能改善.

In addition, three familiar sets of softened compression stress-strain relationship of concrete are showed.

此外, 也给出了常见的三种软化压应力 - 应变关系方程.

According to the P axis superiority distribution position, the compression stress direction is extrapolated.

根据P轴的优势分布方位, 推侧其主压应力方向.

If the stress is above yield point, the column will be destroyed due to compression stress.

时成立.应力在屈服点以上时,由于压缩应力, 柱子将会破坏.

Three compression stress state is the main stress state for three-roll planetary rolling process, which m.

得出在三辊行星轧制过程中起到主要作用的是三向压应力状态, 有利于坯料的大变形和提高轧制管材性能.

Under the control of the stress field due to the tectonic compression in the WE direction and Tectonic process deeply in the area, the formation mechanism of the thrust nappe structure system is closely related to the suture after the collision between Indonesia and Eurasian plate.

受区域上东西向挤压构造应力场和本区深部构造作用所控制，它的形成机制与欧亚板块和印度板块碰撞缝合过程密切相关。

Because the initial tangent modulus decreases gradually with the increase of compression stress and water content and reflects the structural damage increase of loess, this parameter can be used to define the damage variables by the composite theory.

基于初始切线模量定义的损伤比，能够反映球应力增大和进水增湿作用引起的结构破损变化。

The results show that the four failure modes were ranked from highest to lowest effect: slip along the foundation, non-uniform distributions of stress, tension crack of the floodgate heel in the upper stream and compression failure of the floodgate toe in the downstream line.

由计算结果看出，水闸闸室沿闸基面滑动为水闸的最主要失效模式，上下游应力不均匀、上游闸踵拉裂、下游闸趾压坏为次要失效模式。

The floodgate may be regarded as a series system with four main failures modes including slip along the foundation, compression failure of the floodgate toe in the downstream line, tension crack of the floodgate heel in the upper stream and non-uniform stress distributions.

软基上的水闸可看成由4种主要失效模式（沿闸基面的滑动、下游闸趾压坏、上游闸踵拉裂和上下游应力不均匀）所组成的串联体系。